MIL-DTL-398D
constituents or process materials, drawings or specifications
which could affect product uniformity as determined by the
Government. Prior to submission, the contractor shall inspect
the sample to the degree necessary to assure that it conforms to
the requirements of the contract and submit a record of this
inspection with the sample. A sample containing known defects
will not be submitted unless specifically authorized by the
Contracting Officer, (see 6.2).
4.4.2 Inspections to be performed. The sample will be
subjected by the Government to any or all of the examinations or
tests specified in 4.5.2.1 of this specification and any or all
of the applicable drawings. (See DOD-STD-2101 for the
definitions of critical, major and minor classification of
characteristics.)
4.4.3 Rejection. If any sample fails to comply with any of
the applicable requirements (see 3.), the first article quantity
shall be rejected. The Government reserves the right to
terminate its inspection upon any failure of a sample to comply
with any of the requirements.
4.5
Conformance inspection.
4.5.1 Inspection lot formation. The inspection lot shall
consist of one or more batches of RDX produced by one
manufacturer, in accordance with the same specification, or same
specification revision, under one continuous set of operating
conditions. Each batch shall consist of that quantity of RDX
that has been subjected to the same unit chemical or physical
process intended to make the final product homogeneous,
(homogeneity criteria). Units of product selected for inspection
shall represent only the inspection lot from which they are drawn
and shall not be construed to represent any prior or subsequent
quantities presented for inspection. All material submitted for
inspection in accordance with this specification shall comply
with the homogeneity criteria specified herein, regardless of the
type of inspection procedure which is being applied to determine
conformance with requirements. The lot shall be submitted for
inspection in accordance with MIL-STD-1235 when applicable. The
criteria and procedures for the assignment of lot numbers shall
be in accordance with MIL-STD-1168.
4.5.2
Examinations and tests.
a. Classification of characteristics. Conformance
examinations and tests are specified in the following
classification of characteristic paragraphs. The contractor's
quality program or detailed inspection system shall provide
assurance of compliance of all characteristics with the
applicable drawing and specification requirements utilizing as a
minimum the conformance criteria specified. When cited herein
(4.7.9.1 to 4.7.9.5) attributes sample inspection shall be
8
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business