MIL-DTL-45444C
4.4.2 Inspections to be performed. The sample may be
subjected by the Government to any or all of the examinations or
tests specified in 4.5.2.1 of this specification and any or all
of the applicable drawings. (See DOD-STD-2101 for definitions of
critical, major and minor classification of characteristics.)
4.4.3 Rejection. If any sample fails to comply with any of
the applicable requirements (see 3.), the first article quantity
shall be rejected. The Government reserves the right to
terminate its inspection upon any failure of a sample to comply
with any of the requirements.
4.5
Conformance inspection.
4.5.1 Inspection lot formation. A lot shall consist of one
or more batches of HMX produced by one manufacturer, in
accordance with the same specification, or same specification
revision, under one continuous set of operating conditions. Each
batch shall consist of that quantity of HMX that has been
subjected to the same unit chemical or physical process intended
to make the final product homogeneous (homogeneity criteria).
Units of product selected for inspection shall represent only the
inspection lot from which they are drawn and shall not be
construed to represent any prior or subsequent quantities
presented for inspection. All material submitted for inspection
in accordance with this specification shall comply with the
homogeneity criteria specified herein, regardless of the type of
inspection procedure which is being applied to determine
conformance with requirements. The lot shall be submitted for
inspection in accordance with MIL-STD-1235 when applicable. The
criteria and procedures for the assignment of lot numbers shall
be in accordance with MIL-STD-1168.
4.5.2
Examinations and tests.
a. Classification characteristics. Conformance
examinations and tests are specified in the following
classification of characteristics paragraphs. The contractor's
quality program or detailed inspection system shall provide
assurance of compliance of all characteristics with the
applicable drawing and specification requirements utilizing as a
minimum the conformance criteria specified. When cited in the
specification (4.7.9.1 to 4.7.9.5), attributes sample inspection
shall be conducted in accordance with Table III below, using the
inspection levels stated in the classification of characteristics
paragraphs. (See DOD-STD-2101 for definitions of critical, major
and minor classification of characteristics.)
8
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business